Jump to content

Bendalloy "teleporters"


Red Ferring

Recommended Posts

Rereading AoL, and getting refreshed on the basics of Bendalloy, it occurred to me that 2 Sliders, working together, could travel a considerable distance while never leaving the effects of a bubble.

 

When at the edge of your companion's bubble, travel the distance to the opposite edge and put up your bubble. It's said in-story that it takes a moment for a Slider in-between dropping and putting up a bubble, so after however long that is, the first Slider has dropped his original bubble (now in the effects of the second bubble) and travels the distance to the other side of the second Slider's bubble. Then repeat, repeat, repeat. How efficient this is in Bendalloy consumption, I'm not sure. But it cancels the negative of not being able to move your bubble with you.

 

And if they repeat this, 2 Sliders and whoever they brought along for the ride (imagine the compounded effects of 3 or more working together and bubbles overlapping in effect!) would seemingly teleport between 2 points and could quite possibly rival Steelrunners in speed!

Edited by Red Ferring
Link to comment
Share on other sites

What if they were bendalloy/steel twinborn too? They could cover a ridiculous amount of ground that way. And once bendalloy  is commonly available, they could use it to charge their steelminds.

Link to comment
Share on other sites

I actually doubt that Allomantic bendalloy and Feruchemical steel would synergize well together, at least in the "let's team up and teleport" sense that the OP is talking about. The main limiting factor in this technique probably ends up being the "cooldown" time between casting bubbles and/or coordination with the other bubbler more than anything else, rather than how fast you can get from one end of a bubble to another.

Link to comment
Share on other sites

  • Chaos locked this topic
Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...